You are here :

Alu bridge

Made of closed rectangular profiles. With the Albert aluminium walk way you save time and material.

Thanks to its long span this component is ideal for ceiling scaffolds and bridging. In line with DIN 4420 for all maintenance workings of load class 2 (1.5 kN/m²). Suitably erected support that will not tilt must be ensured.

Depending on the length a bearing of 30 to 50 cm is required. If there are several bridges next to one another, they can be made to share a common load by using iron rods, which are slotted through lateral rungs.

Your advantages

Aluminium bridges are normally used for crossing longer distances between two scaffold bays at the highest scaffold level or are used for a planar construct with long range. You can use the Albert-Alu-Bridge with either Unitac or Blitzfix guard rails, because of the holes every 7 cm and the associated guard rail posts, which are available with gravity pins or wedge boxes.

With help of special profiles it is possible that our Aluminium bridges have a permitted load of 2 kN/m², which conformed to load class 3. Aluminium bridges are always in use, where saving of time and material is important.

Downloads

Download catalogue as PDF

Catalogue

Updated 01/2016

Download as PDF